Ways to minimize screen and tip plugging when spraying Quadris on sugarbeets
There are several things sugarbeet growers can do to minimize nozzle and screen plugging when spraying Quadris.
May 8, 2014 - Author: Steven Poindexter, Michigan State University Extension
Almost all Michigan sugarbeet growers are applying Quadris either T-band in-furrow or as a six to eight leaf foliar application for control of Rhizoctonia root rot. Over the years, the Michigan State University Extension Sugarbeet Advancement program has seen various issues that have caused screen and nozzle plugging during applications. Quadris fungicide is only formulated as a flowable product that inherently makes it less friendly to mix compared to an emulsifiable concentrate. Flowable products need constant agitation or settling out will occur. Use low to moderate agitation during spraying. Vigorous agitation appears to often cause the Quadris to form mini-balls that will plug screens.
Best mixing results occur when Quadris is pre-slurried with water then added to water in the tank. Be sure Quadris is fully dispersed in the tank water before adding any other tank mixtures including fertilizers and insecticides. Never add Quadris directly to fertilizers or other products. Agitation is always required as separation and settling will occur. It is not recommended that Quadris be allowed to sit in a tank overnight. It is difficult to get it re-suspended and often screen or nozzle plugging is more evident. As specified on the Quadris label, a 50 mesh screen or courser is recommended between pump and boom or at the nozzle. It is suggested that an extra set of screens be available to rotate as one set is being soaked and cleaned daily.
It appears when band spraying Quadris, fewer problems occur when at least 5 gallons of water per acre are used and the product is applied alone. Many growers are using an insecticide product such as Mustang Max successfully. From observations overtime, it appears that with this tank-mix combination, screens may need more cleaning from slime formation. Colder water temperatures may also aggravate these conditions. Sugarbeet Advancement highly recommends that planters have a way to monitor each spray row such as the Redball system. Often, screens and nozzle may become partially plugged and should be check after each spray or fertilizer fill up.
Growers have reported more mixing and plugging problems from older Quadris as compared to recently manufactured products that are one year or less. If older products are to be used, it would be suggested to use this as a foliar band spray with a higher water volume of 6-8 gallons per acre. Some growers are using or have used compatibility agents in the mix. This appears to be helpful in many cases. If foliar applying Quadris, be certain not to add any oil-based products or silicon adjuvants, as severe leaf burning will occur. If issues develop, contact your local supplier or Brian Devine, Syngenta plant performance specialist, at 989-388-2026.